Optional fantech Mounting Chain Kit for HERO series air exchangers 

fantech 404261 instructions

• Manufacturer: fantech
• Description: Optional Mounting Chain Kit
• Compatibility: fantech HERO series 
• Manufacturers’ Part Number:  404261

(Greater Toronto Area) 

• Two 6″ holes will be cut to your home’s exterior wall for the new weatherhoods.
• Installation Method = “Simplified” (furnace return duct method).
• Installation fee includes proper furnace / HRV interlock setup.
• Typical installations will include two certified HVAC technicians.
• Installation fee includes proper airflow adjustments & accurate air balancing.
• Main or Auxiliary control wiring to upper level may incur additional fee’s.
• Upon Completion of install, full maintenance & operating instructions provided.
• Installation includes a 30-Day Money-Back Satisfaction Guarantee.

• Accessories fee includes properly sized ducting for the recommended air flows.
• Accessories fee includes up to 25 feet of insulated duct.
• Accessories fee includes up to 25 feet of non-insulated duct.
• Accessories fee includes two fixed covered intake & exhaust hoods with mesh

AIR EXCHANGER REPLACEMENT SERVICE    $348.00

AIR EXCHANGER MAINTENANCE VISIT  $96.00

(Greater Toronto Area)

• Remove and clean filters. Vacuum / wash or replace* worn out filters as necessary.
• Remove and clean heat core. Vacuum / wash as necessary.
• Clean interior housing and motor fan blades. Vacuum and wipe clean as necessary.
• Clean the drain line, flush if necessary. Ensure drain trap is properly working. Replacement of broken fittings or blocked drain lines*
• Inspect and clean all interior grilles.
• Inspect and clean exterior weather hoods. Replacement of broken / missing screens. Re-caulk / seal with foam where necessary. replacement of damaged or inferior exterior hoods as necessary*
• Check defrost damper and cold air sensor. Confirm the damper opens, closes and seals properly.
• Inspect insulated flexible duct and reseal where necessary. If insulated duct is wet and soggy, replacement will be advised*
• Inspect non-insulated duct and seal with foil tape where necessary.
• Ensure furnace interlock is working properly. Re-wire if necessary.
• Ensure if installed that the spring-loaded back draft damper is operating properly. (typically located on the “stale air to outside collar”).  Install new damper if required*
• Check wall control to ensure proper operation of HRV.
• Most importantly, measure and properly balance HRV air flows as required by specific HRV manufacturer.